Toolbar | Menu |
---|---|
|
SubD / Mesh Insert Edge |
The InsertEdge command inserts edges beside an edge loop (left) or across an edge ring (right) on a SubD or mesh.
When edges fail to insert, the defective geometry is marked with a text dot. The secondary text in the text dot properties gives a hint of what should be repaired.
Command-line options
Insert edges beside the selected edge loop.
Insert edges on both sides of the selected edge loop.
Insert edges across the selected edge ring.
Select an entire edge loop (left) or ring (right) based on the Type option to insert edges.
Select the start and end edges in a range of loop (left) or ring (right) based on the Type option to insert edges.
The amount is proportional to each crossing edge length. The input number should be between 0 and 1.0.
The amount is same for all edges. The input number is a distance in the model unit.
Expands selected SubD edges into faces.