New in V6 toolbar

To open a toolbar...

Grasshopper

Opens the Grasshopper plug-in window.

Isolate

Hide all but the currently selected objects.

Unisolate

Show objects previously hidden by the Isolate command.

IsolateLock

Lock all but the currently selected objects.

UnisolateLock

Unlock objects previously hidden by the IsolateLock command.

SelPicture

Select all objects created with the Picture command.

SelPlanarSrf

Select all planar surfaces.

SelKey

Select objects by their user attribute key.

SelValue

Select objects by their user attribute value.

SelKeyValue

Select objects by their user attribute key and value.

SelPlanarCrv

Select all planar curves.

SelControlPointRegion

Select a range of control points on a curve or surface.

ShowDirOff

Close the Direction Analysis control, and turn off direction analysis.

SelVolumeObject

Select objects enclosed by an extrusion object, surface, polysurface, or mesh.

SubCrv

Shorten a curve to the new picked endpoints and select.

InfinitePlane

Intersect any plane with objects to return curves or points.

SelFence

Select a using a crossing sketched polyline.

DragStrength

Sets the amount of object drag as a percentage of mouse movement to control the speed of the drag movement.

Parabola3Pt

Draw a parabolic curve through three picked points.

Catenary

Creates a curve that a hanging chain or cable assumes under its own weight when supported only at its ends.

AddGuide

Add temporary infinite guide / construction line.

RemoveGuide

Remove temporary infinite guide / construction line.

Distribute

Spread objects out evenly between the end objects.

OneView

Sets the active construction plane according to the current view direction to accommodate single-window modeling.

ShowEnds

Open the End Analysis control, and display the endpoints of curves.

ShowEndsOff

Close the End Analysis control, and turn off endpoints of curves.

ChangeSpace

Move or copy objects between layout and detail viewports.

SystemInfo

Reports information about the computer hardware and operating system.

MoveExtractedIsocurve

Allows moving an isocurve extracted with the ExtractIsocurve command on the surface it was extracted from.

OffsetMultiple

Copy curves or surface edges parallel to the original.

SelControlPoint

Select all control points.

RemoveAllNakedMicroEdges

Removes very small single naked edges that fold or loop back on themselves and have no matching edge to which they can be joined.

GumballAutoReset

Reset the gumball widget alignment.

CopyHole

Copy a hole in a planar surface.

ShowDir

Open the Direction Analysis control and turn on direction analysis for curves, surfaces, and polysurfaces.

ShowDirOff

Close the Direction Analysis control, and turn off direction analysis.

FilletEdge, Edit

Edit a tangent surface between polysurface edges.

Notifications

The Notifications command opens the Notification panel.

AddNgonsToMesh

Converts regions of connected coplanar welded faces into Ngons.

DeleteMeshNgons

Converts Ngons on a mesh into triangle or quad faces.

PropertiesPage, Thickness

Constructs a mesh offset based on the object's render mesh.

DevLoft

Creates a single developable surface between two rails.

MeshFromLines

Create a mesh from intersecting lines.

Raytraced viewport display mode

Display the viewport with real-time rendering that supports calculating reflection and refraction.

 

 

 

Rhino 6 for Mac © 2010-2020 Robert McNeel & Associates. 11-Nov-2020