New in V6 toolbar

Opens the Grasshopper plug-in window.

Shows the plug-ins used in the currently loaded Grasshopper file.

Hide all but the currently selected objects.

Unisolate

Lock all but the currently selected objects.

UnisolateLock

Select all objects created with the Picture command.

Select all planar surfaces.

Select objects by their user attribute key.

Select objects by their user attribute value.

Select objects by their user attribute key and value.

Select all planar curves.

Select a range of control points on a curve or surface.

ShowDirOff

Select objects enclosed by an extrusion object, surface, polysurface, or mesh.

Shorten a curve to the new picked endpoints and select.

Intersect any plane with objects to return curves or points.

Select a using a crossing sketched polyline.

Sets the amount of object drag as a percentage of mouse movement to control the speed of the drag movement.

Draw a parabolic curve through three picked points.

Creates a curve that a hanging chain or cable assumes under its own weight when supported only at its ends.

Add temporary infinite guide / construction line.

RemoveGuide

Spread objects out evenly between the end objects.

Sets the active construction plane according to the current view direction to accommodate single-window modeling.

Open the End Analysis control, and display the endpoints of curves.

ShowEndsOff

Move or copy objects between layout and detail viewports.

Reports information about the computer hardware and operating system.

Allows moving an isocurve extracted with the ExtractIsocurve command on the surface it was extracted from.

Copy curves or surface edges parallel to the original.

Select all control points.

Removes very small single naked edges that fold or loop back on themselves and have no matching edge to which they can be joined.

Reset the gumball widget alignment.

Copy a hole in a planar surface.

Open the Direction Analysis control and turn on direction analysis for curves, surfaces, and polysurfaces.

ShowDirOff

The Notifications command opens the Notification panel.

Converts regions of connected coplanar welded faces into Ngons.

Converts Ngons on a mesh into triangle or quad faces.

Constructs a mesh offset based on the object's render mesh.

Creates a single developable surface between two rails.

Create a mesh from intersecting lines.

Display the viewport with real-time rendering that supports calculating reflection and refraction.