Angle
| Toolbar | Menu |
|---|---|
|
|
Analyze Angle |
The Angle command reports the angle between two sets of locations in degrees.
The angle is that between picked points that represent the endpoints of two lines.
Steps
- Pick the start of an imaginary angle line.
Snap to existing geometry to establish the lines. - Pick the end of an imaginary angle line.
- Pick the start of a second imaginary angle line.
- Pick the end of a second imaginary angle line.
The angle between the imaginary lines is reported on the command line.
| Command-line options | |
|---|---|
|
TwoObjects |
Measures the angle between two planar surfaces or two lines. |
|
Type subcrv to select part of a curve as input. |
|
