Box

Toolbar	Menu
Box Main Main1 Solid Creation Solids Sidebar	Solid Box > <Options>

Toolbar

Solid

Box >

The Box command creates an Extrusion box.

The UseExtrusion command decides if an Extrusion or a polysurface box is created.

Pick two points for the opposite corners of the base rectangle.

Press and hold Shift to draw a square.

Or, select one of the options to draw the rectangle in a different way.
Pick the height.

Press Enter to use the width value for the height.

Command-line options

Creates a box from the diagonal corners. If you pick the two corners on the CPlane, the command prompts for picking the height.

Creates a box with six square faces from the diagonal corners.

Draws the rectangle using two opposite corners.

Draws the rectangle using two adjacent corner locations and a location on the opposite side.

Draws the rectangle from the midpoint of the first edge, an end of the edge, and a location on the opposite side.

Draws the rectangle perpendicular to the construction plane.

Draws the rectangle from the center point and a corner.