OffsetNormal
Toolbar | Menu |
---|---|
|
Curve Offset > Offset Normal to Surface |
The OffsetNormal command copies a curve on a surface in the normal direction of the surface so that all locations on the copied curve are a specified distance from the original curve.
Steps
-
Select a curve on a surface.
-
Select the base surface.
-
Specify the offset distance.
The selected curve is pulled back to the surface first. The offset distance is calculated from the surface.
-
Pick a base point to set another distance, or press Enter if the offset should be a uniform distance from the original.
Infinite Plane: Type IP for InfinitePlane options.
Command-line options | |
---|---|
SetBasePoint |
Specifies the first point for a distance for the offset if it should be different from the point where the curve was selected. |
Flip |
Reverses the direction. Positive values for the distance follow the direction arrows. |