# CloseCrv

The CloseCrv command closes open curves.

Curves are closed either with a straight segment or, if they are within joining of one another, by moving the curve end point to the curve start point.

#### Steps

- open curves and press .

The number of curves closed by adding segments and the number closed by moving endpoints are reported.

Command-line options

##### CloseWideGapsWithLine (Yes/No)

Gaps larger than the tolerance setting would be closed with a line (Yes), or left open (No).

##### Tolerance

The degree of accuracy required.

If Tolerance is set to zero, all selected open curves are closed by moving endpoints.

## See also

Draw lines and curves

Rhinoceros 7 © 2010-2023 Robert McNeel & Associates. 03-May-2023