TruncatedCone

Toolbar Menu

Solids Creation
Solids Sidebar

Solid

Truncated Cone

The TruncatedCone command draws a cone whose apex is truncated by a plane.

Steps

  1. Draw the base circle.

  2. Pick a location or type a number to set the height.

    The positive direction of the height is different based on the selected DirectionConstraint option.

  3. Draw the end circle.

Base circle options

DirectionConstraint

Direction constraints restrict the direction of the truncated cone.

None

Pick or type a number to set the height.

Vertical

Creates a truncated cone perpendicular to the construction plane.

AroundCurve

Draws the base circle perpendicular to the picked point on a curve. The center line of the truncated cone will be tangent to the curve.

Solid

Caps the top and bottom openings or leave them open.

Radius

Draws the base circle by picking the center point and a radius point.

Diameter
Circumference
Area
ProjectOsnap

2Point

Draws the base circle from two opposite points.

3Point

Draws the base circle through three points.

Radius

Tangent

Draws the base circle tangent to one, two, or three curves.

Point
FromFirstPoint
Radius

FitPoints

Draws the base circle by fitting to selected points, control points, or mesh vertices.

End circle options

Radius

Pick a location or enter a number to set the end circle radius.

Diameter

Pick a location or enter a number to set the end circle diameter.

See also

MeshTruncatedCone

Draw a mesh truncated cone.

 

 

 

Rhinoceros 6 © 2010-2020 Robert McNeel & Associates. 11-Nov-2020