FitSrf

The FitSrf command tries to reduce the number of surface control points while maintaining the surface's same general shape.

Steps

1. Select surfaces.
2. Type a new tolerance value or press Enter to accept the default.
3. Type 0 (zero) to use the current absolute tolerance.

Note

Use the FitSrf command for replacing surfaces with too many control points.
When the input to the FitSrf command is a wiggly surface with lots of control points, the FitSrf command tries to compute a surface that has the same general shape but fewer control points.

Command-line options

DeleteInput

Yes

Deletes the original geometry.

No

Retains the original geometry.

ReTrim

Trims the new fit surface with the original trimming curves.

UDegree/VDegree

The degree of the surface in the u -or v-direction.

OutputLayer

Specifies the layer for the results of the command.

Current

Places the results on the current layer.

Input

Places the results on the same layer as the input curve.

TargetObject

Places the results on the same layer as the target surface.

See also

Edit surfaces


Rhinoceros 5 © 2010-2015 Robert McNeel & Associates. 17-Sep-2015