Planar

Toolbar Menu Alias Application Toolbar

Not on toolbars.

Not on menus.

P

Planar

The Planar command limits successive picked locations to the same construction plane elevation as the previous location.

Planar mode aids in creating planar objects with commands that allow free picking. Successive points have the same construction plane elevation.

Example

  1. From the Curve menu, click Free-form, then click Control Points.
  2. Pick the first point in the lower part of the Top viewport.
  3. Move the cursor to the Front viewport and continue drawing.
    You will see that all the points you pick define a planar curve at the same elevation in the Front viewport. (Watch the Top and Right viewports). That elevation for the Front viewport was defined by the very first point you placed in the Top viewport.
    With Planar off, the subsequent points would be at elevation 0 in the Front viewport.

Note

SetPlanar

Toolbar Menu

Not on toolbars.

Not on menus.

The SetPlanar command turns Planar mode on, off, or toggles the current state.

Steps

Command-line options

On

Turns planar mode on.

Off

Turns planar mode off.

Toggle

Toggles planar mode.

See also

Use modeling aids

 

 

 

Rhino for Mac © 2010-2017 Robert McNeel & Associates. 24-Oct-2017