Toolbar | Menu |
---|---|
|
Surface Surface Edit Tools > Match |
The MatchSrf command adjusts the edge of a surface to have position, tangent, or curvature continuity with another surface.
Command-line options | |
---|---|
MultipleMatches |
Allows selection of more than one edge to match.
|
ChainEdges |
Selects surface edges that are touching the selected curve. |
Match Surface Options
Sets the continuity for the match.
Location only.
Position and direction.
Position, direction, and radius of curvature.
Changes the surface structure to prevent modification of the curvature at the edge opposite the match.
No constraint.
Location only.
Position and curve direction.
Position, direction, and radius of curvature.
Both surfaces are modified to an intermediate shape. If the target surface is also untrimmed, the surfaces match by averaging the two.
Aligns the surface being changed to the target edge in two ways:
Stretches or compresses the surface to match the entire edge end to end, or pulls each point object on the edge to the closest point object on the other edge.
Determines if the match results should be tested for accuracy and refined so the faces match within tolerance. If necessary, Rhino adds knot lines to the modified surface or surfaces until the surfaces are within tolerance.
Position matching in model units.
Tangency matching.
Curvature matching, in percent of the radius of curvature.
Specifies the way the parameterization of the matched surfaces is determined.
If the target edge is not trimmed, it works like the Match target isocurve direction option.
If the target edge is trimmed, it works like the Make perpendicular to the target edge option.
Does not change the existing isoparametric curves directions.
The isoparametric curves of the surface will be parallel to those of the target surface.
The isoparametric curves of the surface will be perpendicular to the target surface edge.
Visually evaluate surface smoothness and continuity using a stripe map.
Rhino for Mac © 2010-2017 Robert McNeel & Associates. 24-Oct-2017