PushPull toolbar
![](../image/command_icons/pushpull.png)
PushPull
Extrudes a polysurface face to interactively add or remove volumes on the polysurface.
![](../image/command_icons/splitface.png)
SplitFace
Divides the selected surface of a polysurface by drawing a polyline, selected curves, or isocurves.
![](../image/command_icons/dupfaceborder.png)
DupFaceBorder
Creates a curve that copies a polysurface face border.
![](../image/command_icons/inset_mesh.png)
Inset
Offsets the edges of selected mesh, SubD, or polysurface faces in a certain distance towards the center of each face.
![](../image/command_icons/mergecoplanarface.png)
MergeAllCoplanarFaces
Combines the faces of each planar region on a mesh, polysurface, or SubD into a single face.
![](../image/command_icons/autoaligncplane.png)
AutoAlignCPlane, Enabled
Toggles Auto CPlane on/off.
![](../image/command_icons/autoaligncplane_rt.png)
AutoAlignCPlane, Sticky
Toggles the sticky mode of Auto CPlane on/off.