Drape

The Drape command creates a surface through points defined at the intersection of objects and points projected toward the construction plane in the current viewport.

Note

• Drape works over meshes or meshable objects (surfaces, polysurfaces, etc.). Non-meshable objects (curves, annotations, clipping planes, etc.) will be ignored.
• Drape samples locations in the render depth buffer (z buffer) and then uses them for the surface control point locations. Because of this, the surface will always sag more than the original.
• The Drape command uses the deepest point in the view for the base level of the drape surface. It only sees mesh or render mesh objects.

The DrapePt command creates a grid of point objects at the intersections of objects and points projected toward the construction plane in the current viewport.

Note:

DrapePt works over meshes or meshable objects (surfaces, polysurfaces, etc.). Non-meshable objects (curves, annotations, clipping planes, etc.) will be ignored.

See also

Point

Create surfaces