TextObject

Toolbar Menu

Main
Main1

Solid

Text

The TextObject command draws text-shaped curves, surfaces, or polysurfaces based on TrueType fonts.

Steps

  1. Specify options.
  2. Pick a location.

Text Object options

Height ___ <units>

Sets the text height in model units.

Font

The text appearance.

Tip: Click to open the drop-down list, and type the initial letter of a font to find the font quickly.

Upper case

Changes all letters in the selected text to uppercase.

Lower case

Changes all letters in the selected text to lowercase.

Capitalize words

Changes the first letters of the words in the selected text to uppercase, all the other letters to lowercase.

Invert case

Reverts uppercase and lowercase in the selected text.

Text alignment
Left align text

Sets the horizontal text alignment to the left.

Center align text

Sets the horizontal text alignment to the center.

Right align text

Sets the horizontal text alignment to the right.

Top align text

Sets the vertical text alignment to the top.

Middle align text

Sets the vertical text alignment to the middle.

Bottom align text

Sets the vertical text alignment to the bottom.

B

Sets the font style to bold.

I

Sets the font style to italic.

Toggle stacking brackets

The toggle stacking brackets button is a shortcut to add or remove [[...]] around text selected in the edit box. Stacking brackets will make the text between them stack, so that [[1/2]] will display as a stacked fraction.

Degree

Enters a degree symbol (°) into the text.

Radius

Enters a radius symbol (R) into the text.

Diameter

Enters a diameter symbol (Ø) into the text.

Plus/Minus

Enters a plus/minus symbol (±) into the text.

Rotation

Sets the rotation angle for the text.

Edit box

Output

Specifies the output object type.

Curves

Creates text using outline curves.

Surfaces

Creates text using planar surfaces.

Solids

Creates text using solids.

Thickness

Specifies the solid thickness.

Group output

Groups resulting text objects.

Allow single-stroke fonts

This option is only useful for single-stroke engraving fonts unknown to Rhino. Always leave this option unchecked unless the single-stroke font used has an unexpected look as below.

 

There are three types of engraving fonts, single-stroke, double-stroke and double-thin.


Single-stroke
Double-stroke
Double-thin

Rhino keeps a list of single-stroke and double-stroke fonts. If you use one on the list, Rhino will try the following:

The Double-thin fonts are standard outline fonts with a constant width. Allow single-stroke fonts may remove necessary lines.

Lower case as small caps

Displays lower-case letters as small caps. Set the relative text size to a percentage of the normal text.

Add spacing

Adds spacing between letters.

Use text center to position

When placing the text, the cursor will appear at the center of the text.

See also

Use text and dimensions for annotation

 

 

 

Rhinoceros 6 © 2010-2019 Robert McNeel & Associates. 27-Nov-2019