Toolbar  Menu 


Solid Ellipsoid > <Options> 
The Ellipsoid command draws a solid NURBS ellipsoid.
Commandline options
Creates an ellipsoid by defining the halflength of each axis.
Draws the base ellipse from the center point and a corner of the enclosing rectangle.
Draws the base ellipse from two opposite corners of the enclosing rectangle.
Creates an ellipsoid by defining the length of each axis.
Draws the base ellipse perpendicular to the construction plane.
Draws the ellipse from focus points and a point on the curve.
Places a point object at the focus locations.
Draws the base ellipse perpendicular to the picked point on a curve. The third axis will be tangent to the curve.
Draw a mesh ellipsoid.
Rhinoceros 6 © 20102020 Robert McNeel & Associates. 13Oct2020