Where can I find this command?
The ExtrudeSrfToPoint command creates a solid by tracing the path of the surface edges tapering to converge at a selected point.
Notes
| ● | If the curve is not planar, then it will be extruded in the z-direction of the active viewport's construction plane. If the curve is planar, it will be extruded in the normal direction of the plane of the curve. |
| ● | Unlike Lofts and Sweeps, the initial orientation of the profile curve or surface is maintained through the extrusion. |
| ● | If the input is a non-planar polycurve or a planar polycurve where the extrusion direction is not normal to the curve plane, the result will be a polysurface rather than an extrusion object. |
Command-line options
Solid
If the profile curve is closed and planar, both ends of the extruded object are filled with planar surfaces and joined to make a closed polysurface.
DeleteInput
Yes
Deletes the original geometry.
No
Retains the original geometry.
ToBoundary
Extrudes the object to a boundary surface.
See also
Rhinoceros 5 © 2010-2015 Robert McNeel & Associates. 17-Sep-2015
