The DupEdge command creates a curve that duplicates a surface edge.
Steps
Select the edges of a surface.
Note: The curve has a different control points structure than the original curve used to trim the surface.
Command-line options
OutputLayer
Specifies the layer for the results of the command.
Current
Places the results on the current layer.
Input
Places the results on the same layer as the input curve.
TargetObject
Places the results on the same layer as the target surface.
See also
Create curves from other objects
Rhinoceros 5 © 2010-2015 Robert McNeel & Associates. 17-Sep-2015