Where can I find this command?
Ribbon 指令可將曲線偏移，並在兩條曲線之間建立規則曲面。
指令行選項
Distance
設定偏移距離。
角
Specifies how offset corner continuity handled. These options only apply if the offset direction is to the "outside" as shown in the image.
Original curve (blue). Offset to outside (red). Offset to inside (green).
Sharp
Curves offset to the outside of a corner will be extended to meet at sharp corners with position (G0) continuity.
Round
Curves offset to the outside of a corner will be filled with arc segments with tangent (G1) continuity.
Smooth
Curves offset to the outside of a corner will be filled with blend segments with curvature (G2) continuity.
Chamfer
以直線填補偏移產生的缺口。
通過點
指定偏移曲線的通過點，不使用輸入數值的方式設定偏移距離。
公差
設定曲線偏移的公差。
Type 0 to use the default system tolerance.
兩側
將曲線往兩側偏移。
與工作平面平行
否 - 在曲線平面上偏移曲線 (僅適用於平面曲線)，是 - 往與工作平面平行的方向偏移。
請參考
History enabled.