ExtrudeSrfToPoint

Toolbar	Menu
Extrude Solid	Solid Extrude Surface> Extrude Surface to Boundary> To Point

Toolbar

Toolbar: Extrude Solid

Solid

Extrude Surface>

Extrude Surface to Boundary>

To Point

The ExtrudeSrfToPoint command creates a solid by tracing the path of the surface edges tapering to converge at a selected point.

If the curve is not planar, then it will be extruded in the z direction of the active viewport's construction plane. If the curve is planar, it will be extruded in the normal direction of the plane of the curve.
Unlike Lofts and Sweeps, the initial orientation of the profile curve or surface is maintained through the extrusion.
If the input is a non-planar polycurve or a planar polycurve where the extrusion direction is not normal to the curve plane, the result will be a polysurface rather than an extrusion object.

Command-line options
Solid	If the profile curve is closed and planar, both ends of the extruded object are filled with planar surfaces and joined to make a closed polysurface.
DeleteInput	Yes Deletes the original geometry. No Retains the original geometry.
ToBoundary	Extrudes the object to a boundary surface.

Command-line options

Solid

If the profile curve is closed and planar, both ends of the extruded object are filled with planar surfaces and joined to make a closed polysurface.

DeleteInput

Deletes the original geometry.

Retains the original geometry.

ToBoundary

Extrudes the object to a boundary surface.

See also