Toolbar | Menu |
---|---|
|
Panels Box Edit |
The BoxEdit command edits objects according to their bounding box size, orientation, and position.
New bounding boxes are calculated each time the settings are applied.
Box Edit Panel
Reports the number of objects selected.
Save the changes.
Rejects the changes and revert the objects to their previous state.
Use any units to specify sizes.
Specifies the x, y, or z size in model units.
Increment used by the spinner controls.
Specifies the x, y, or z scale factor.
Increment used by the spinner controls.
Specifies the x, y, or z position in model units.
Increment used by the spinner controls.
Specifies the x, y, or z rotation in degrees.
Increment used by the spinner controls.
Sets the base point for scale and rotate transforms.
Sets the x, y, or z location.
Uses the minimum bounding box x, y, or z point.
Set X, Y, and Z to Min to use the "lower-left" corner of the bounding box as the pivot.
Uses the centroid bounding box x, y, or z point.
Set X, Y, and Z to Cen to use the "middle" of the bounding box as the pivot.
Uses the maximum bounding box x, y, or z point.
Set X, Y, and Z to Max to use the "upper-right" corner of the bounding box as the pivot.
Uses world coordinates for the transformations.
Uses construction plane coordinates for the transformations.
Transforms each object from its own pivot point and bounding box.
By default, selected objects are all contained in one bounding box and are transformed from one pivot point as one unit.
Displays a control polygon that represents the bounding box.
Transforms a copy instead of the original objects.
Leaves the copied objects selected. This allows incremental changes to the copied objects.
Rhino for Mac © 2010-2017 Robert McNeel & Associates. 24-Oct-2017