NetworkSrf
| Toolbar | Menu |
|---|---|
|
|
Surface Curve Network |
The NetworkSrf command creates a surface from a network of crossing curves.
-
All curves in one direction must cross all curves in the other direction and cannot cross each other.
-
The command always smooths out the output surfaces even if the input curves have kinks.
Steps
-
Pick the curves in two directions that form a network.
Or, use Windows-selection.
Command-line options
NoAutoSort
Turns off automatic sorting so you can select the curves manually.
Surface from Curve Network Options
Tolerances
Edge curves
Sets the tolerance for the edge curves. The edges of the surface will be within this value from the edge curves.
Interior curves
Sets the tolerance for the interior curves. The interior of the curve's surface will be within this value.
If the curves themselves are farther apart from each other than the tolerance values, the best guess is made at the surface.
Angle
If the edge curves are surface edges, and you want the surface matching the adjacent surfaces with tangency or curvature continuity, this is the accuracy used to match the surface normals.
Edge Matching
Determines how the edges match the input geometry.
Loose
The surface will match to the input edge curves with less accuracy.
Position / Tangency / Curvature
Sets the continuity for the edge match.
Preview
Displays a preview of the surface.