MergeCrv

Toolbar

Menu

Not on toolbars.

Not on menus.

The MergeCrv command combines curves connected end to end into a single curve. This command is similar to the MergeSrf command that works with surfaces.

Steps

  1. Select curves connected end to end.

  2. Set command-line options.

Command-line options

Tolerance

If the gap between two curve ends is larger than this value, the two curves will not be merged.

Roundness (0~1)

Controls the smoothness of the output curve where two input curves are connected. 0 simply joins the curves into a polycurve.

DeleteInput
Yes

Removes the input curves when the command is done.

No

Keeps the input curves when the command is done.

 History enabled

SubCrv

Type subcrv to select part of a curve as input.

See also

CurveThroughPolyline

Create a curve from polyline vertices.

CurveThroughPt

Fit a curve through point objects.