# TruncatedCone

Solid

Truncated Cone

The TruncatedCone command draws a cone whose apex is truncated by a plane.

#### Steps

1. Draw the base circle.

2. Pick a location or type a number to set the height.

The positive direction of the height is different based on the selected DirectionConstraint option.

3. Draw the end circle.

Base circle options

##### DirectionConstraint

Direction constraints restrict the direction of the truncated cone.

##### None

Pick or type a number to set the height.

##### Vertical

Creates a truncated cone perpendicular to the construction plane.

• The CPlane +Z direction is the positive direction when you type a number to set the height.
##### AroundCurve

Draws the base circle perpendicular to the picked point on a curve. The center line of the truncated cone will be tangent to the curve.

• The curve direction is the positive direction when you type a number to set the height.

### Solid

Caps the top and bottom openings or leave them open.

Draws the base circle by picking the center point and a radius point.

##### 2Point

Draws the base circle from two opposite points.

##### 3Point

Draws the base circle through three points.

##### Tangent

Draws the base circle tangent to one, two, or three curves.

##### FitPoints

Draws the base circle by fitting to selected points, control points, or mesh vertices.

End circle options

Pick a location or enter a number to set the end circle radius.

##### Diameter

Pick a location or enter a number to set the end circle diameter.