Slab
| Toolbar | Menu |
|---|---|
|
|
Solid Slab |
The Slab command offsets a curve, extrudes and caps the result to create a solid.
Steps
- Select a curve.
The Slab command uses the construction plane in the view where you pick the offset as the ground plane. The Slab command offsets the curve to create a base for the slab and then extrudes the base to make a solid with mitered corners. - Pick a side to offset.
- Pick a distance.
- Pick the height.
Command-line options
Distance
Sets the offset distance.
Loose
The Corner and Tolerance options are not shown and do not affect the output. Polycurves are offset as a group of separate curve segments, and there is no corner trimming or filling.
ThroughPoint
Offsets through a picked point instead of at a distance.
BothSides
Offsets the curve on both sides of the input curve.
InCPlane
The curve is offset in the plane of the original curve. This option offsets the curve in the plane of the current construction plane instead.
OutputLayer
Current
Place the results on the current layer.
Input
Place the results on the same layer as the input objects.