Curve
Curve Edit Tools >
Match
| Toolbar | Menu |
|---|---|
|
|
Curve Curve Edit Tools > Match |
The Match command changes a curve end to meet a specified curve or surface edge with a specified continuity.
| Command-line options | |
|---|---|
|
SurfaceEdge |
Matches the curve perpendicular to the curve and uses the surface to determine continuity. |
Match Curve Options
Sets the continuity for the match.
Prevents modification of the curvature at the end opposite the match for curves with fewer than six control points.
No constraint.
Location only.
Position and curve direction.
Position, direction, and radius of curvature.
Sets the curve perpendicular to a surface edge.
Both curves adjust to match each other.
Joins the resulting curves.
Merge is available with the Curvature option, and it makes a single curve instead of a composite curve. If you edit this curve's control points, the location where the two original curves match will deform smoothly. You cannot explode the curve into the segments that were originally matched.
Rhino 6 for Mac © 2010-2020 Robert McNeel & Associates. 11-Nov-2020