FitSrf

Toolbar

Menu

Toolbar: Surface Tools

Surface

Surface Edit Tools >

Refit to Tolerance

The FitSrf command tries to reduce the number of surface control points while maintaining the surface's same general shape.

Steps

Select surfaces.
Type a new tolerance value or press Enter to accept the default.
Type 0 (zero) to use the current absolute tolerance.

Note

Use the FitSrf command for replacing surfaces with too many control points.
When the input to the FitSrf command is a wiggly surface with lots of control points, the FitSrf command tries to compute a surface that has the same general shape but fewer control points.

Command-line options
DeleteInput	Yes Deletes the original geometry. No Retains the original geometry.
ReTrim	Trims the new fit surface with the original trimming curves.
UDegree/VDegree	The degree of the surface in the u or v direction.
OutputLayer	Specifies the layer for the results of the command. Current Places the results on the current layer. Input Places the results on the same layer as the input curve. Note: If the input object is in a model that is attached using Worksession, the object will be placed on the current layer. TargetObject Places the results on the same layer as the target surface.

See also

Rhino 6 for Mac © 2010-2020 Robert McNeel & Associates. 11-Nov-2020