Ortho

Toolbar	Menu	Shortcut	Alias	Application Toolbar
Object Snap	Not on menus.	Shift F8	O	Ortho

The Ortho command restricts the movement of the cursor to multiples of a specified angle from the last point created.

Note

• The Ortho command, clicking Ortho in the status bar, and the F8 key, are all toggles. Holding Shift changes the mode while you hold the key down.
• The SetOrtho command prompts for a setting with the options On, Off, and Toggle. This is useful for inclusion in a script for the ReadCommandFile command.
• When Ortho is on, marker movement is restricted to points at multiples of a specified angle from the last point created. The default angle is 90 degrees.

Toolbar	Menu
Object Snap	Not on menus.

The OrthoAngle command specifies the angle the movement of the cursor is restricted to when ortho mode is active.

Toolbar	Menu	Status bar
Not on toolbars.	Not on menus.	Ortho > Ortho On/Off

The SetOrtho command turns ortho mode on, off, or toggles the current state.

This is useful for inclusion in a script file for the ReadCommandFile command.

Command-line options
On	Turns ortho mode on.
Off	Turns ortho mode off.
Toggle	Toggles ortho mode.

See also

Use modeling aids

Model with precision

Cursor constraints