Toolbar | Menu |
---|---|
|
Solid Box > <Options> |
The Box command creates an Extrusion box.
The UseExtrusion command decides if an Extrusion or a polysurface box is created.
Command-line options
Creates a box from the diagonal corners. If you pick the two corners on the CPlane, the command prompts for picking the height.
Draws the rectangle using two opposite corners.
Draws the rectangle using two adjacent corner locations and a location on the opposite side.
Draws the rectangle from the midpoint of the first edge, an end of the edge, and a location on the opposite side.
Draws the rectangle perpendicular to the construction plane.
Draws the rectangle from the center point and a corner.
Rhinoceros 7 © 2010-2024 Robert McNeel & Associates. 10-Apr-2024