OffsetMultiple

Toolbar	Menu
Curve Tools	Not on menus.

Toolbar

Toolbar: Curve Tools

Not on menus.

The OffsetMultiple command copies multiple curves so that all locations on the copied curves are a specified distance from the original curve.

All open curves offset toward the cursor.
When offsetting closed curves, if the side-to-offset point is inside a curve, the offsets for other closed curves will also be inside.
Islands (closed curves inside other closed curves) are recognized and offset in the opposite direction from the container closed curves.

Select curves and edges.
Click on to specify the side.
For best results, use proportionately small offset distances and smooth curves; otherwise, you may get kinks and doubled-back curves.

Command-line options
Distance	Sets the offset distance.
Corner	Specifies how offset corner continuity handled. These options only apply if the offset direction is to the "outside" as shown in the image. Original curve (blue). Offset to outside (red). Offset to inside (green). Sharp Curves offset to the outside of a corner will be extended to meet at sharp corners with position (G0) continuity. Round Curves offset to the outside of a corner will be filled with arc segments with tangent (G1) continuity. Smooth Curves offset to the outside of a corner will be filled with blend segments with curvature (G2) continuity. Chamfer The corners of the offset curves will be filled with a straight line between their endpoints.
OffsetCount	Specifies the number of curves that will be created.

Command-line options

Distance

Sets the offset distance.

Corner

Specifies how offset corner continuity handled. These options only apply if the offset direction is to the "outside" as shown in the image.