SrfSeam

The SrfSeam command changes the location on a closed surface where the start and end edges of the surface meet.

Steps

1. Select a closed surface.
2. The seam of the surface is indicated by a curve.
3. Click to pick a new location for the seam point.

Command-line options

Note: Options are only available if the surface is closed in two directions (such as a torus).

U

Changes the seam in the u-direction.

V

Changes the seam in the v-direction.

Both

Changes the seam in both u- and v-directions.

See also

Edit surfaces


Rhinoceros 5 © 2010-2015 Robert McNeel & Associates. 17-Sep-2015