Sphere
Solids Sidebar
Solids Creation
Solid
Sphere
Center, Radius
2 Points
3 Points
4 Points
Around Curve
Tangent to Curves
Fit Sphere to Points
The Sphere command draws a solid sphere.
Steps
Pick the center and radius for the base circle.
Note: See the Circle command for option descriptions.
Command-line options
4Point
Draws the sphere based on three points that define a circumference and a point to establish the location.
4Point steps
1. | Pick three points, or two points and a Radius, to define a circle that will lie on the sphere. |
2. | If no Radius is specified, pick a fourth point to specify the sphere's location. The fourth point sets the size of a sphere constrained by the circle. |
See also
Rhinoceros 5 © 2010-2015 Robert McNeel & Associates. 17-Sep-2015