RoundHole

The RoundHole command creates circular holes in surfaces or polysurfaces.

Steps

1. Select a surface.
2. Pick a center point on the surface, or specify a command line option.

Command-line options

Depth

Depth of the hole.

Radius/Diameter

Radius or diameter of the hole.

DrillPointAngle

Sets the angle at the bottom of the hole. If the angle is 180 degrees, the hole bottom is flat.

Through

Cuts the hole completely through the solid. The Depth setting is ignored.

Direction

Specifies the direction for the hole.

SrfNormal

Uses the surface normal direction.

CPlaneNormal

Draws the hole perpendicular to the active construction plane.

Pick

Two points establish the extrusion direction angle.

Pick steps

1. Pick a base point.
2. Pick a second point to establish the direction angle.

Undo

The Undo option reverses the last action.

See also

Create and edit holes in surfaces


Rhinoceros 5 © 2010-2015 Robert McNeel & Associates. 17-Sep-2015