RebuildCrvNonUniform

The RebuildCrvNonUniform command interactively modifies selected curves by non-uniformly re-spacing the control points.

Steps

1. Select the curves.

2. Drag the points on the curves.
3. Click the direction arrows to reverse the curve direction.

Command-line options

RequestedTolerance

Specifies the maximum distance the rebuilt curves can deviate from the originals. If you do not provide enough control points, the rebuilt curves may deviate more than RequestedTolerance from the originals.

The maximum deviation from the original curves is reported at the command line and marked with a point on the curve.

MaxPointCount

Specifies the maximum number of control points per curve used to rebuild.

Quarters

Displays two more controls along each curve to influence how the RebuildCrvNonUniform command distributes control points. The controls at the end of the curves can be used to shorten the resulting curves.

DeleteInput

Yes

Deletes the original geometry.

No

Retains the original geometry.

ResetPoints

Resets the editing points to their original locations.

See also

Edit curves


Rhinoceros 5 © 2010-2015 Robert McNeel & Associates. 17-Sep-2015