Where can I find this command?
The Ortho command specify the angle at which the movement of the cursor is restricted when ortho mode is active.
The Ortho command restricts the movement of the cursor to multiples of a specified angle from the last point created.
Note
| ● | The Ortho command, clicking Ortho in the status bar, and the F8 key, are all toggles. Holding Shift changes the mode while you hold the key down. |
| ● | The SetOrtho command prompts for a setting with the options On, Off, and Toggle. This is useful for inclusion in a script for the ReadCommandFile command. |
| ● | When Ortho is on, marker movement is restricted to points at multiples of a specified angle from the last point created. The default angle is 90 degrees. |
The OrthoAngle command specifies the angle at which the movement of the cursor is restricted when ortho mode is active.
Steps
Type the new angle.
The SetOrtho command turns ortho mode on, off, or toggles the current state.
This is useful for inclusion in a script file for the ReadCommandFile command.
Command-line options
On
Off
Toggle
See also
Rhinoceros 5 © 2010-2015 Robert McNeel & Associates. 17-Sep-2015
